Euronorm EN10215

Comments

The yield strength Re, the ultimate tensile strength Rm and the elongation A are measured on an 20/80 cross-strip test piece.

One can count on minimum values of 140 N/mm² for Re and 270 N/mm² for Rm.

For thickness below 0.7 mm, the minimum guaranteed value for A should be reduced by 2 units for all grades.

Grade DX54D+AZ is non-aging (nochange in the mechanical properties in the 6 months following delivery).

For other grades please contact the sales organization.

Comments

The yield strength Re, the ultimate tensile strength Rm and the elongation A are measured on an 20/80 lengthwise test piece.

For thickness below 0.7 mm, the minimum guaranteed value for A should be reduced by 2 units for all grades.

Coatings

The coatings available are given in the following table.

pon request, other coatings can be achieved.

1/ By th measurement method given as an annex to the EN10215 standard.

2/ By way of indication, a 3,75 g/m² deposite is equal to the thickness of 1 um on a surface of 1 m²

Surface finish

Aluzinc-plus is available in two surface finishes as specified in the table.